SURFACE PREPARATION
Prior to application of Glaze ‘N Seal products, surface must be thoroughly clean and dry. Remove all dirt, oil, grease, paint, efflorescence and non-compatible sealers. General cleaning may be done using Glaze ‘N Seal Heavy Duty Cleaner for Concrete and Masonry. For efflorescence and hard water stains, use Glaze ‘N Seal Efflorescence Remover. When acid has been used for any reason, surface must be neutralized. Allow at lease 48 hours of drying time before sealing (72 hours if power washing has been done or if temperature is cool). New concrete pavers should cure 14 days or more before sealing. Applying sealer to a damp or incompletely cured surface may cause a hazy appearance or loss of adhesion.
After tamping down the joint sand (regular or polymeric) and sweeping the application area clean, be sure the sand is at least 1/8-inch below the surface of the pavers. The sand should be dry to its full depth before sealing for the best results.
Note. Before applying Glaze ‘N Seal products to the entire surface, test several small areas to verify the product’s appearance, penetration and protective ability.
APPLICATION PROCEDURE
Use garden-type, solvent resistant sprayer, low pressure airless sprayer, or natural bristle brush and non-foam squeegee for application.
Rollers are not recommended when applying the Wet Look Paver Sealer. Apply one coat in liberal, saturating manner so that joints are saturated with Paver Sealer. Ensure that all joints are flooded to maximize sealer soaking into the dry sand. Squeegee any excess product to avoid puddling on the surface. Allow additional drying time in moist, cool climates. An optional second coat may be applied after two hours if desired to increase protection and gloss. For added slip resistance, Glaze ‘N Seal Grip ‘N Seal slip resistance additive may be added to the second coat of sealer.
COVERAGE
100-250 square feet per gallon depending on porosity of surface and method of application. Second coat will go 50% further. Do not puddle or over apply.
WARRANTY
Glaze ‘N Seal Product liability, either expressed or implied, is limited solely to the replacement of this product when proven to be defective and does not include any labor costs or consequential damages. It is the user’s responsibility to determine the safety, toxicity and suitability of this product.
SAFETY INFORMATION
Product contains petroleum distillates. Read product label carefully before use.
KEEP OUT OF REACH OF CHILDREN. VOC <100g/l.
ADVANCED PAVER CARE PRODUCT LINE
“Wet Look” Paver Sealer is part of Glaze ‘N Seal’s Advanced Paver Care line of products to protect, maintain, and restore. This state of the art product line includes enhancer sealers, cleaning and restoration products. All products are safe, effective and easy to use.
For additional information, contact your Glaze ’N Seal dealer or contact Glaze ‘N Seal directly (1800-486-1414, info@glaze-n-seal.com).